![]() I then factory defaulted the access point via SSH using the command syswrapper.sh restore-defaultĪfter the AP rebooted I could then successfully perform the set-inform. I again attempted to issue the set-inform command without luck. I removed the device from the controller using Select Device => Config => Manage Device => Forget the device option. Issue the following command: set-inform The UniFi device will now show up for adoption and can be treated as a standard L2 adoption. You may refer to our guide on how to Login with SSH. You can refer to our UniFi Device LED Status guide. Through default, the access point will search the network on and controller, using the default DNS name unifi. The Set-Inform URL say the Unifi Gain Indent where the controller belongs located. ![]() The device will show up for adoption on ALL sites in your UniFi controller, use the sites drop down in the upper right corner to switch to the site you want the device to be adopted in, then click 'Adopt'. Within this article, I will explaining how you can use the Set-Inform command on the Unifi Access Point. When connecting to it via SSH and issuing the info command I was getting the Server Reject message Make sure your device is in a factory-default state. Using the open window for SSH, type in the set-inform URL, you can locate your HostiFi hostname from the portal, at. I once had an access point that was working fine and then just stopped talking to the controller, it showed as disconnected on the controller. After issuing the set-inform, the UniFi device will show up for adoption. The issue was I had entered the controller address currently but missing the /inform from the end of the URL.Īlways check the basics! Solution 2 – Factory default via-ssh/ WebTutorial How to Adopt Unifi via SSH. So I spent far too long once trying to work out why a new out the box switch would not talk to the controller. When you SSH into the device and issue the “info” command you are greeted with the message “Status: Server Reject” Solution 1 – Check your URL ere is the process on how to set the Inform URL manually via SSH. So I have had it with a new out the box device and also when moving a device to a different part of the LAN. The custom SSH username and word are ubnt. You don’t need an SSH client for aforementioned, ours cannot single use PowerShell for this, that is installed by default on all Windows 10 and 11 home. So I thought I would start to document the resolutions as and when it happens. To set the inform URL us need go connect over SSH to the Unifi access point. ![]() This will permanently save the inform address, and the device will. Once the device goes offline, issue the command set-inform in step 1 again. Once you click adopt, the device will appear to go offline. This is an issue I have had a couple of times. SSH into the device and type the following and hit enter: 2. Setting the inform address for an Unifi device fails with “Status: Server Reject”. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |